NAVIGATION: GPS Module GY-NE06MV2

The **GY-NEO6MV2 GPS Module** is a stand-alone GPS receiver that uses the high-performance u-blox 6 positioning engine to determine its location on Earth. The module comes with an external antenna and built-in EEPROM. It has four pins: VCC, RX, TX, and GND. The module communicates with the Arduino via serial communication using the TX and RX pins. The module can be powered using an input voltage range of 3V to 5V. 

Source: Conversation with Bing, 1/5/2024

GPS Module with Antenna
Ublox NEO-6M GPS Module
High Sensitivity Active Antenna
With battery backup for quick GPS lock

Wiring :

• On this example, it needs 10k ohms and 4.7k ohms resistor to the RX pin.

Code :

Downloads :